Kristin Rutten

How to Make Bias Tape Piping Tutorial

Bias tape piping, often referred to simply as “piping,” can add a very professional, tailored look to your doll sewing projects. But if you live in a small area like I do, sometimes it’s hard to find piping in a color to match your fabric.

Or perhaps you’d like to use patterned piping, such as that shown in our Any Way You Slice It Purse shown below, for an extra splash of fun!

The solution? Make your own piping from your chosen fabrics! (Just THINK of the possibilities!)






FREE printable PDF of this tutorial when you join my Inner Circle!

How to Make Bias Tape Piping Tutorial

How to Make Bias Tape Piping

Tools Needed

• Sewing machine
• Clear acrylic quilting ruler (with angle markings)
• Rotary cutter & self-healing mat
• Iron & ironing board
• Seam alignment guide (click HERE to download)
• Sewing pins

Supplies Needed
MakeBiasTape-9

Can’t find cording? Try round shoelaces!

• Fabric
• Thread
• 1/8-inch diameter cording or braided nylon rope (make sure it bends easily and isn’t too stiff for a sewn project)


Instructions

1. Press your fabric and lay it out flat on your cutting mat with your selvage(s) on the left side. (Your fabric may be in a single layer or, if more piping is desired, folded with both selvages lined up on the same side.)

How to Make Bias Tape Piping Tutorial

2. Using your clear acrylic quilting ruler and rotary cutter, cut the bottom edge of your fabric so that it is straight at a 90° angle to the selvage.

How to Make Bias Tape Piping Tutorial

3. Find the 45° mark on your quilting ruler and line it up so the 45° degree line on the ruler is right along the selvage edge of your fabric.

How to Make Bias Tape Piping Tutorial

4. With your ruler still in place, cut a length of fabric from edge to edge at that 45° angle.

How to Make Bias Tape Piping Tutorial

5. Use your ruler to make another cut parallel to your first to create a 1-inch wide strip.

How to Make Bias Tape Piping Tutorial

6. Continue cutting parallel 1-inch strips of fabric.

How to Make Bias Tape Piping Tutorial

7. Use the downloadable seam alignment guide to pin your strips together along the short angled ends with right sides facing each other. (If your selvage is wider than 1/4 inch, you may need to trim the ends of your strips prior to pinning. When doing so, be sure to make the cuts parallel to the selvage.)

How to Make Bias Tape Piping Tutorial

8. Stitch strips together using a 1/4-inch seam allowance.

How to Make Bias Tape Piping Tutorial

9. Press seams toward one side. Trim off the fabric corners that extend beyond the edge of the strip.

How to Make Bias Tape Piping Tutorial

10. Starting at one end of the strip, fold the fabric wrong sides together, aligning raw edges, and press. Continue folding and pressing as you work down the length of the strip.

How to Make Bias Tape Piping Tutorial

11. Starting at one end of your fabric strip, place the cording inside the fold, pushing it into the folded edge and leaving an inch or two of the cording sticking out of that end. Realign the raw edges of the fabric and pin in place. Continue pinning the cording inside the strip of fabric until you reach the end. Cut off the cording, leaving a tail of at least a few inches. (As you get the hang of this, you may choose to skip the pinning, just slipping the cording into the fold as you stitch.)

How to Make Bias Tape Piping Tutorial

12. Using a zipper foot and a 1/4-inch seam allowance, stitch the fabric together, removing the pins as you go. Take it slowly, using your fingers to keep everything aligned, and be careful not to stitch into the cording itself.

How to Make Bias Tape Piping Tutorial

13. Trim the excess cording from both ends of your piping. If desired, wind the piping onto a piece of cardboard. Your piping is now ready for use!

How to Make Bias Tape Piping Tutorial



FREE printable PDF of this tutorial when you join my Inner Circle!

Permission to Get Creative

This tutorial was written for use with woven cotton fabrics, but feel free to experiment with other types, such as satins, polyester blends … or perhaps even knits! You may also wish to experiment with different types or sizes of cording or adjust the width of your fabric strips, depending upon the project on which your piping will be used.

Matilda’s Closet is not affiliated with American Girl® or Mattel®. No endorsement is implied.

Save

About Kristin Rutten

Kristin Rutten is the creator, owner and operator of Matilda Jo Originals. Born and raised in Montana, she first learned to sew on her grandmother's antique Singer sewing machine by cutting out and stitching a simple nine-square pillow. Other projects soon followed and she has been crafting and sewing ever since. In addition to sewing and pattern design, she also enjoys crocheting, scrapbooking and designing WordPress websites, including sister company iCreateForDolls.com. She makes her home in Central Montana with her husband and four children, ages 9 to 22.

View All Posts

2 Comments

  1. Kim
    KimReply
    May 25, 2018 at 8:20 am

    I signed up for inner circle a while ago. I wanted to download this off to my tablet to use the directions offline. How or where do you login to do so?

    • Kristin Rutten
      Kristin RuttenReply
      May 25, 2018 at 9:35 am

      Hi Kim! The free PDF version was delivered via a “Welcome” email when you first signed up for the Inner Circle. There is a download link in that email. Please check your email inbox to see if you can find that email … if you don’t find it, email me directly at support@clubmatilda.com and I can send that file to you.

Leave a Reply

Name*
Email*
Url
Your message*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>